Page 1 of 1

Fitting Plastic Finger Picks

PostPosted: Sun Apr 08, 2012 1:00 pm
by Bant's Bluz
This subject has been bandied about quiet a bit, but I was given some Dunlop tortise shell appearing finger picks. In thier present condition I can't use them. I've read about soaking the picks in hot water, then slipping them onto the fingers, but I can't remember if the water was supposed to be boiling or just what.
Pointers are appreciated.

Re: Fitting Plastic Finger Picks

PostPosted: Sat Jun 30, 2012 9:06 pm
by bottleneck
i do it with water below boilng,or with a hot hair dryer.

www.shakeylee.com